CONTROL, REMOTE SWITCHING (SMART START) {W/TSU} [NARTRON]

On Sale: $1,355.41 MSRP: $1,692.76

NSN

6110-01-542-7901

MORE DETAILS DOES IT FIT? GOVT SURPLUS FITMENT RELATED

IMPORTANT PART NOTE:

NO ADDITIONAL DETAILS AVAILABLE AT THIS TIME

IMPORTANT PART NOTE:

EFFECTIVE 09-01-2018: YES THESE ARE NEW...NO WARRANTY IS ISSUED WITH THESE BOXES. WE ARE SICK OF SENDING OUT REPLACEMENTS ONLY TO FIND OUT PEOPLE AREN'T INSTALLING THEM PROPERLY (WE INCLUDE INSTRUCTIONS OR THEY ARE CLAIMING BAD BOXES BECAUSE THEY AREN'T TROUBLESHOOTING THEIR OWN VEHICLE)...IF YOU BUY IT YOU OWN IT, NO RETURNS ALLOWED. THESE UNITS ARE VERIFIED WORKING AT THE FACTORY SO IF YOU PURCHASE ONE AND SOMETHING DOESN'T WORK IT IS EITHER A COMBINATION OF YOUR TSU CONNECTOR, GROUND POINTS, FAULTY WIRE HARNESS, ETC. AKA ALMOST 99.999999% NEVER FAIL DUE TO THE NEW CONTROLLER AND TSU THAT WAS JUST PURCHASED. DO NOT PURCHASE THIS UNLESS YOU AGREE TO NO WARRANTY

ADDITIONAL PART NOTE:

IT IS HIGHLY RECOMMENDED THAT YOU ALSO REPLACE GLOWPLUGS AT THE SAME TIME (GLOWPLUGS & SMART START/TSU)...IF YOU HAVE BLOWN GLOWPLUGS AND YOU INSTALL THE NEW SMART START/TSU IT WILL SENSE IF THE GLOWPLUGS ARE WORKING OR NOT - AKA YOU MAY BLAME A NEW BOX FOR NOT WORKING. YOU CAN CHECK IF THE GLOWPLUGS ARE BURNED OUT BY OHM (TIP TO GROUND WHEN INSTALLED). ZERO OHMS MEANS BURNED OUT, IDEAL 1.8 TO 3.0.)

IF YOU CONTINUALLY BLOW GLOWPLUGS OUT THAT IS YOUR BOX SENDING 24V ALL THE TIME TO THEM AFTER THE ENGINE IS RUNNING, IT WILL START GREAT 1 TIME ONLY AND THEN THE PLUGS WILL BURN OUT...IF THAT HAPPENS YOUR BOX NEEDS TO BE REPLACED OR YOUR GENERATOR NEEDS TO BE REPLACED. (ENSURE THE "AC" TAP IS FUNCTIONING AT WIRE 2A REF SERVICE MANUAL, VOLTAGE SHOULD BE BETWEEN 9-16V DC - IF VOLTAGE IS NOT PRESENT GLOWPLUG SYSTEM WILL NEVER STOP CYCLING)

THE OLDER BOXES PUT "BRAINS" IN THE BOX UNDER THE STEERING COLUMN AND THE CONTROLLER IN THE THERMOSTAT HOUSING...THE NEWER SMART START BOX PUTS ALL THE "BRAINS" IN THE BOX UNDER THE STEERING COLUMN AND SENSES TEMP ONLY AT THE THERMOSTAT HOUSING (HENSE THE DIFFERENT TECHNOLOGY). TROUBLESHOOTING IS ENTIRELY DIFFERENT, THE MANUALS ARE WRONG/INCORRECT FOR REFERENCING THE NEWER BOXES, IT ALMOST ALWAYS IS BAD GROUNDS OR ENGINE WIRING ISSUES.

REPLACES THESE BOXES (WILL UPDATE AS MORE ARE DOCUMENTED):
01-491-2142 / CR2699 - OBSOLETE (REPLACE WITH 01-542-7901)
01-395-9585 / CR2692 - OBSOLETE (REPLACE WITH 01-542-7901)
01-463-9260 - OBSOLETE (REPLACE WITH 01-542-7901)
01-470-1931 - OBSOLETE (REPLACE WITH 01-542-7901)
01-292-6532 - OBSOLETE (REPLACE WITH 01-542-7901)
01-491-2152 - SSI (REPLACE WITH 01-542-7901)
01-491-2158 - OBSOLETE (REPLACE WITH 01-542-7901)
01-542-7668 - KDS BOX ONLY (REPLACE WITH 01-542-7901)

YOU CANNOT INTERMIX KDS, NARTON, ETC WITH EACH OTHER'S COMPONENTS THEY WILL NOT WORK PROPERLY.

INCLUDES TEMP SENDING UNIT (TSU). TSU = TEMP SENDING UNIT. MUST BE PAIRED WITH THE NEWER STYLE SMART START BOX AND CANNOT BE USED WITH THE OLDER GLOW PLUG CONTROLLER VERSION OR IT WILL NOT WORK PROPERLY/CAUSE DAMAGE TO THE CONTROLLER.

HPG ETM (ELECTRONIC TECH MANUAL) LOCATIONS - IF AVAILABLE. CLICK ON THE LINK TO VIEW A VISUAL LOCATION FOR THAT ITEM.


HPG ETM > HMMWV > 6.5L TURBO DIESEL > ELECTRICAL SYSTEM > 54 - DIRECTIONAL CONTROL UNIT, PROTECTIVE CONTROL BOX AND DIRECTIONAL FLASHER

BELOW ARE THIS PART'S MATCHED USED ON CODES (UOC) TO DETERMINE PROPER FITMENT. THESE CODES ARE CONSTANTLY BEING UPDATED. CONTACT US IF YOU HAVE QUESTIONS.

---

NOTE: Part data was compiled by HPG. Please don't copy it for eBay listings, your website or anything else. Karma will hunt you down if you decide to copy it.

BELOW ARE THIS PART'S MATCHED USED ON CODES (UOC) TO DETERMINE PROPER FITMENT. THESE CODES ARE CONSTANTLY BEING UPDATED. CONTACT US IF YOU HAVE QUESTIONS. HOVER OVER THE MODEL TO SEE ADDITIONAL DETAILS

---

NOTE: Part data was compiled by HPG. Please don't copy it for eBay listings, your website or anything else. Karma will hunt you down if you decide to copy it.

12338771-8 / 01-188-3863

GLOW PLUG (24V) {SET OF 8) [GEP]

In Stock @ HPG (WI Warehouse)

$87.20 $74.99

View Details

---

Do I have a Hummer H1 or Surplus HMMWV(R)? Does it really matter...

Answer: YES

While some parts will fit either chassis there are certain unique parts and if you incorrectly interchange them THEY WILL NOT FIT. (pause and re-read that again)

The key difference, and it makes the whole experience better in buying and owning your vehicle, starts with the VIN or SERIAL Number. KNOW WHAT YOU OWN. You do NOT own a 1989 Hummer H1...you own a 1989 HMMWV®. You do NOT own a 2004 M1123 Hummer H1..you own a 2004 M1123. So knowing you have a surplus HMMWV® or Hummer H1 you can now properly get the correct fan clutch (because there are 4 clutch options)...get it?

Hummer H1: Vin starts with 137# (#= D, F, L, P, X, Y OR Z ) Total of 17 digits. Example 137YA8338TE123456. Vin is located on the windshield frame, frame rail and door frame. This vehicle was DOT certified/crash tested, is ONLY 12V and meant for the highway/offroad.

Surplus HMMWV(R)): Serial numbers are 6 numeric digits located on the driver door data plate, next to the body style tag MXXXX. (Example: 125611, M998). Unless you are armed forces this is a military surplus vehicle, is ONLY 24V from the factory and meant for battle.